Troubleshooting
Cold Room Icing Up
Ice on the floor, on the ceiling or around the evaporator: what it means and why it gets worse quickly.
Ice in a cold room is never just cosmetic. It reduces usable space, becomes a slip hazard, and usually signals that the room is fighting moisture it should not be seeing. Left alone, ice on the evaporator insulates the coil, cuts capacity and pushes the compressor towards failure.
The cause is one of four things: a defrost cycle that is not completing, a blocked or frozen drain, warm humid air entering through a door or seal, or a room whose insulation and vapour seal have given up. The fix depends entirely on which one it is.
Symptoms
What you are seeing.
- Ice on the floor, usually near the door or under the evaporator
- A thick ice layer on the evaporator coil or ceiling panels
- The room takes far longer to recover after the door is opened
- Water pooling instead of draining away
- The compressor runs almost continuously
Likely causes
What usually causes it.
- A defrost timer, heater or termination sensor that has failed
- A blocked or frozen condensate drain
- Damaged door seals or a door left open during deliveries
- A failed vapour seal letting humid air into the panels
- Warm, humid air from a kitchen or back room being drawn in
Before you call
What you can check yourself.
- Note whether the ice is on the floor, the ceiling or the coil
- Check the door closes and seals along its full height
- Look for water in the drain tray or a frozen drain line
- Avoid chipping ice with a sharp tool: it damages panels and coils
Questions
Asked most often.
Can I just switch the room off and let it thaw?
It will clear the ice, but the cause remains and the ice returns within days. A thaw is a useful diagnostic step, not a repair.
Why does ice form near the door?
Warm humid air entering each time the door opens. A damaged seal, a missing strip curtain or a door that does not close fully will all do it.
Is ice on the ceiling a panel problem?
Often yes. Moisture inside the panel structure points to a vapour seal failure, which no amount of refrigeration adjustment will fix.
Local versions
Cold room icing in a specific suburb
The service behind this guide: Cold roomsEnquire
Still not right?
Send the details and we will confirm the next available visit. Enquiries are handled centrally at info@reyds.co.za.