Mitchells Plain · Cape Town

Heat pump not heating in Mitchells Plain

In Mitchells Plain heat pumps are often installed against a boundary wall with little clearance, and recycling cold air is the first thing we check.

A heat pump that runs without heating is almost never a mysterious fault. It is usually not getting enough air, not getting enough water flow, or has lost refrigerant. Each of those shows up differently, which is why the checks below start with the simple ones.

Cold weather makes everything harder. A unit sized in summer may struggle in July, and a pool without a cover loses heat faster than any heat pump can replace it. If the unit has never performed well, sizing and siting are worth reviewing before parts are replaced.

Mitchells Plain was laid out from the 1970s onwards, and that history shows in the housing: rows of face-brick and plastered family homes, many extended over the years with a flatlet, a backyard room or a converted garage. Those extensions change how a house holds heat. A room added on the sunny side, without insulation in the roof, will sit several degrees warmer than the rest of the house by mid-afternoon, and a unit sized for the original layout will not fix it.

Symptoms

What Mitchells Plain callers describe.

  • The fan runs but the water temperature does not rise
  • The unit runs for a few minutes then stops
  • Ice forms on the outdoor coil and does not clear
  • The unit is noisier than usual or vibrates
  • The pool or geyser heats slowly, then not at all

Likely causes

Where we look first.

  • Low water flow from a blocked strainer, pump or bypass
  • A dirty evaporator coil restricting airflow
  • Insufficient clearance around the unit, causing it to recycle cold air
  • Low refrigerant charge from a leak
  • A failed sensor, controller or reversing valve

Local conditions

What is different in Mitchells Plain.

  • Extended family homes where added rooms gain far more heat than the original house
  • Summer afternoons well into the thirties, hotter than the coastal suburbs
  • Dust and sand from the Cape Flats settling in condenser coils and filters
  • Single-phase household supplies with limited spare capacity for new equipment
  • Small shops, takeaways, bakeries and crèches running commercial refrigeration from home premises

Before you call

What you can check yourself.

  • Check the pool pump or circulation pump is running and the strainer is clear
  • Confirm there is clear space around the unit for air to enter and leave
  • Look for ice on the coil and note whether it clears
  • Check the controller setpoint and whether the unit is in the mode you expect

Questions

Why does the unit ice up in winter?

Some frosting is normal in cold humid air and the unit should defrost itself. Ice that stays means the defrost cycle is not completing, which needs testing.

Can a heat pump heat a pool in Cape winter?

It can, but output drops as air temperature falls and a cover becomes essential. Expect slower heating and be honest with yourself about the temperature you want.

Is it cheaper to run at night?

If your tariff allows it, yes, but a pool loses heat overnight. A cover matters more than the time of day.

Keep reading

Heat pump not heating in other suburbs

Enquire

Heat pump not heating in Mitchells Plain.

Tell us the equipment, the symptom and how urgent it is. If stock is at risk, say so when you send it.

Best way to reach you

Your details are used only to respond to this enquiry. See our privacy note.