Mitchells Plain · Cape Town

Tripping the power in Mitchells Plain

In Mitchells Plain older single-phase boards often carry more than they were designed for, and adding a cold room can push a marginal circuit over the edge.

A refrigeration unit that trips the distribution board is doing what it should: protecting the circuit. The reason could be a failing compressor, a short in the wiring, a water-damaged connection or a supply that was never adequate for the load.

Do not keep resetting the breaker. Each reset sends current through a fault, and a compressor that could have been repaired can be destroyed this way. Switch the unit off at the isolator and have it tested.

Mitchells Plain was laid out from the 1970s onwards, and that history shows in the housing: rows of face-brick and plastered family homes, many extended over the years with a flatlet, a backyard room or a converted garage. Those extensions change how a house holds heat. A room added on the sunny side, without insulation in the roof, will sit several degrees warmer than the rest of the house by mid-afternoon, and a unit sized for the original layout will not fix it.

Symptoms

What Mitchells Plain callers describe.

  • The breaker trips when the unit tries to start
  • The unit trips only after running for a while
  • The plug or socket is warm or discoloured
  • Other equipment on the same circuit also loses power
  • A burning smell near the unit or the board

Likely causes

Where we look first.

  • A failing compressor drawing locked-rotor current
  • A start capacitor or relay that has failed
  • Moisture in an electrical connection or a damaged cable
  • A circuit that was never sized for the equipment added to it
  • An earth leakage fault from a water-damaged component

Local conditions

What is different in Mitchells Plain.

  • Extended family homes where added rooms gain far more heat than the original house
  • Summer afternoons well into the thirties, hotter than the coastal suburbs
  • Dust and sand from the Cape Flats settling in condenser coils and filters
  • Single-phase household supplies with limited spare capacity for new equipment
  • Small shops, takeaways, bakeries and crèches running commercial refrigeration from home premises

Before you call

What you can check yourself.

  • Switch the unit off at the isolator rather than repeatedly resetting the breaker
  • Note whether the trip happens on start-up or after a period of running
  • Check for water around the unit or a damp plug point
  • Move stock to another cabinet if the unit will be off for a while

Questions

Can I plug the fridge into another socket?

Only as a temporary measure on a circuit that can carry it. If the fault is in the unit, it will trip that circuit too.

Is it dangerous to keep resetting the breaker?

Yes. Repeated resets stress the compressor and can worsen an electrical fault. Switch it off and have it tested.

Will I need an electrician?

Sometimes. If the fault is in the fixed wiring or the board, an electrician is the right person. We test the appliance side and tell you which it is.

Keep reading

Tripping the power in other suburbs

Enquire

Tripping the power in Mitchells Plain.

Tell us the equipment, the symptom and how urgent it is. If stock is at risk, say so when you send it.

Best way to reach you

Your details are used only to respond to this enquiry. See our privacy note.