Mitchells Plain · Cape Town
High pressure alarm in Mitchells Plain
In Mitchells Plain chillers on roofs and back walls collect dust quickly, and a blocked coil is behind most high pressure trips we attend.
High pressure means the chiller cannot get rid of heat fast enough. The trip is protecting the compressor, so resetting it without finding the cause simply repeats the cycle. In Cape Town's dusty conditions the answer is usually at the condenser.
Work through airflow, then water flow, then charge. A blocked coil, a failed fan, a dirty strainer or air in the water circuit will all produce the same alarm, and each has a different fix.
Mitchells Plain was laid out from the 1970s onwards, and that history shows in the housing: rows of face-brick and plastered family homes, many extended over the years with a flatlet, a backyard room or a converted garage. Those extensions change how a house holds heat. A room added on the sunny side, without insulation in the roof, will sit several degrees warmer than the rest of the house by mid-afternoon, and a unit sized for the original layout will not fix it.
Symptoms
What Mitchells Plain callers describe.
- The chiller trips on high pressure after a short run
- Head pressure readings are high with a normal water temperature
- Condenser fans are not running or run at one speed only
- The condenser coil is visibly blocked with dust or debris
- The alarm repeats more often on hot afternoons
Likely causes
Where we look first.
- A blocked or dirty condenser coil
- Restricted airflow from enclosure, recirculation or failed fans
- Low water flow from a blocked strainer or failing pump
- Overcharge or non-condensables in the refrigerant circuit
- A faulty high pressure switch or transducer
Local conditions
What is different in Mitchells Plain.
- Extended family homes where added rooms gain far more heat than the original house
- Summer afternoons well into the thirties, hotter than the coastal suburbs
- Dust and sand from the Cape Flats settling in condenser coils and filters
- Single-phase household supplies with limited spare capacity for new equipment
- Small shops, takeaways, bakeries and crèches running commercial refrigeration from home premises
Before you call
What you can check yourself.
- Confirm the condenser fans are running
- Look through the coil for dust, leaves or building debris
- Check the pump is running and the strainer is clear
- Note the ambient temperature and time of day when the trip occurs
Questions
Can I reset the chiller and keep running?
You can reset it, but if the cause is still there it will trip again, and repeated trips stress the compressor. Find the cause first.
Why does it only trip in summer?
Higher ambient temperature reduces the condenser's ability to reject heat. A coil that is marginal in winter will fail in February.
How often should the condenser be cleaned?
Quarterly for most units in this dust, more often if the chiller sits near a road, a kitchen extract or a building site.
Keep reading
High pressure alarm in other suburbs
Enquire
High pressure alarm in Mitchells Plain.
Tell us the equipment, the symptom and how urgent it is. If stock is at risk, say so when you send it.